BadgerMeter electromagnetic flowmeter M2000

SPECIFICATIONS

• Power supply

  85 – 265 VAC, 45/65 Hz, less than 20 VA or optional 9–36 VDC

• Analog output

  0/4 - 20 mA, ≤800 ohms, flow direction is indicated on a separate logic output

• Logic/frequency output

  2 open-collector outputs active 24Vdc/20mA or passive 30Vdc/100mA max. 10 kHz
  2 SSR outputs max. 48Vac/500mA,
  1 kHz or passive open collector max. 30Vdc/100mA, 10 kHz
  
  
  1/2

• Logic output functions

  Min/max alarm, preselection, flow direction, error message

• Empty tube detection

  Separate electrode

• Programming

  3 front panel buttons

• Interface

  RS232 Modbus® RTU as standard
  RS485 Modbus® RTU, M-Bus, HART™ & Profibus-DP optional

• Flow scale

  0.03 – 12 m/s

• Accuracy

  When the flow velocity is greater than or equal to 0.5 m/s – accuracy is better than ±0.2 % of the measured flow value
  When the flow velocity is less than 0.5 m/s – ±1.25 mm/s from the measured flow velocity

• Repeatability

  0,1 %

• Flow direction

  Bidirectional

• Pulse length

  Programmable up to 10 s

• Outputs

  Short-circuit protection and galvanic isolation

• Low-flow shutdown

  0–10 %

• Display

  LCD, 4 lines / 20 characters, backlit, current flow rate, 2 totalizers, status display

• Housing

  Cast aluminum

• Protection

  IP67

• Cable gland

  Power supply and outputs: 3 x M20

• Sensor cable

  Signal to detector cables: M20

• Ambient temperature

  -20°C to +60°C

AVAILABLE MODELS

DOCUMENTS

• Manual: Electromagnetic flow meter M2000

  1.55MB

  Download

• Manual: M2000 HART® electromagnetic flowmeter

  421.95 KB

  Download

• Datasheet: Electromagnetic flow meter M2000

  844.75 KB

  Download

• Brochure: Electromagnetic flow meters

  650.15 KB

  Download

• Brochure: Measures for energy and the environment

  4.01 MB

  Download